Skip to content

NFC-1 introduction

The Apollo NFC-1 with its white case open on a wooden table, showing the green circuit board with the Apollo logo and NFC-1 REV-1 printed on it

The Apollo NFC-1 is an NFC reader, writer, and emulator that runs ESPHome and connects to Home Assistant. Tap a tag or card on it and Home Assistant gets a tag scan, ready to run an automation.

Scan tags into Home Assistant: Every tag you tap shows up under Settings → Tags in Home Assistant, and its UID and content land on the NFC-1's device page. Use a tag by the door, the bed, or your desk to arm the alarm, start a bedtime scene, or switch on work mode.

Write, clean, and format tags: Write a URL, a line of text, or a brand-new Home Assistant tag from your dashboard, with no phone app needed. After every write, the NFC-1 reads the tag back to check it. Clean or format a tag to reuse it.

Card emulation: Turn on Card Emulation and the NFC-1 acts as a tag itself. Visitors tap their phone on it to open a link, such as your guest page or a menu. On Android, it can open the Home Assistant app.

Feedback you can see and hear: An RGB LED and a buzzer confirm every scan, write, and error. Adjust the brightness and volume, or turn either one off.

Bluetooth proxy: Place the NFC-1 where Bluetooth is weak and switch on its Bluetooth proxy to relay nearby BLE sensors and devices to Home Assistant.

Updates over the air: Update the firmware from Home Assistant, on the Stable or Beta channel.

What's in the box

  • NFC-1

The Apollo NFC-1 in its closed white case on a wooden table

Product details

Spec Detail
NFC controller NXP PN7160
Microcontroller ESP32-C6 with 8MB flash
Connectivity Wi-Fi and Bluetooth LE (Zigbee and Thread capable at chip level)
Tag modes Read, Write, Clean, Format
Write types URLs (up to 120 characters), text, and Home Assistant tags, with an automatic check after each write
Card emulation Acts as a tag for phones to tap, with an optional Home Assistant app launch on Android
Supported tags NTAG / MIFARE Ultralight and MIFARE Classic
Feedback RGB LED and buzzer, with adjustable brightness and volume
Setup Improv over Bluetooth or USB serial, plus a Wi-Fi fallback hotspot
Firmware Open source ESPHome. Custom builds need ESPHome 2026.8 or newer. Source on GitHub.

Get started with your NFC-1 Join our Discord if you need more help!