Putting the MTR-1 in boot mode

This will cover how to put the MTR-1 into boot mode.

This is needed to force the device into boot mode to reflash the firmware.

Method 1: Boot button only

You'll hold the boot button while you plug in the USB-C cable.

1. Position the MTR-1 as shown in the image below and locate the small opening to press the boot button (the right button).

2. Push and hold the boot button. While still holding the button down, plug in a USB-C cable into the USB-C port of your MTR-1 then let go of the button.

3. Continue with uploading the firmware document.

Method 2: Boot and reset buttons

You'll use the boot and reset buttons together while the device is plugged into your computer.

1. Unplug the device and locate the boot button (the right opening, shown in the image above) and the reset button (the left opening, shown in the image below).

2. Plug it into your computer.

3. Hold down the boot button (the right button), then press and release the reset button (the left button) while keeping the boot button pressed. Finally, release the boot button.

4. Continue with uploading the firmware document.