Skip to content

Attaching the bottle to the PUMP-1

You'll fit the input fluid level sensor into the base, then slide the water bottle into it.

1. Begin by placing the small white connector through the hole in the base of the water bottle and gently press the input fluid level sensor into place.

Make sure to orient your fluid level sensor correctly as shown in the gif below

The fluid sensor needs to be placed with the flat side with no writing facing outwards and the side with the ears flush with the back towards the plastic enclosure.

Fitting the input fluid level sensor into the PUMP-1 bottle base, then sliding the bottle in

2. (Optional) Gently press the cable into the built-in cable slots located on the underside of the 3D-printed base. This helps keep the wiring neat and secure.

3. Slide the bottle into the base until it is securely seated.

Click here to learn how to attach the inlet and outlet tubes!