Skip to content

Putting The PUMP-1 In Boot Mode

This will cover how to put the PUMP-1 into boot mode.

This is needed to force the device into boot mode to reflash the firmware.

Method 1: Boot Button Only

Empty the water reservoir and make sure no water is present in the tubes

Make sure that there is no water which is able to damage the device. This is a precautionary measure just to be safe!

1. Disconnect your PUMP-1 from power. With the device facing you, locate the boot button—it’s the button on the right.

2. Plug in a USB cable that supports power and data into your computer.

3. Push and hold the boot button (the right button). While still holding the button down, plug in a USB-C cable into the USB-C port of your PUMP-1 then let go of the button.

4. You are now ready to reflash your device!

Click here to go to the reflashing guide!

Method 2: Boot and Reset Buttons

1. Plug in a USB cable that supports power and data into your computer and connect the other end to your PUMP-1. With the device facing you, locate the reset (left) and boot (right) buttons.

2. Hold down the boot button (the right button), then press and release the reset button (the left button) while keeping the boot button pressed. Finally, release the boot button.

3. You are now ready to reflash your device!

Click here to go to the reflashing guide!