MTR-1
Setup
Getting Started
Please refer to the general getting started article
Sensor Definitions
Component The ld2450 component enables the use of the HLK-LD2450 human presence and moti...
Bluetooth Tracking with MTR-1
Please refer to the general Bluetooth tracking article
General Tips
MTR-1 PCB with Sensors Light Sensor (LTR-390UV) When mounting the MTR-1 be sure to posi...
How To Change The Update Frequency Of Sensors/Force Update
How To Change The Update Frequency Of Sensors/Force Update
Zone Configuration Using Home Assistant
Disclaimer: Currently having issues saving the zones after restarting the device when using this ...
Zone Configuration Using HLKRadarTool App
1. Download the HLKRadarTool app for either Android or Apple2. Ensure the mmWave radar you want t...
Calibrating And Updating
Examples
MTR-1 Home Assistant Dashboard Examples
Radar Scatter Plot With Apex Charts type: custom:apexcharts-card header: show: true tit...
Using MTR-1 Buzzer
This guide will walk you through using the buzzer on your MSR-1. You can also call the below serv...
How To Use The Apollo GPIO Header To Control An LED Strip
This tutorial will guide you through setting up one of our MSR-2 devices (works with any mezzan...
MTR-1 Automation Guide
MTR-1 Examples From GitHub
https://github.com/ApolloAutomation/MSR-1/tree/main/Examples
MTR-1 + Alarmo Home Security Install
My grandmother wanted a security system that would alert her when there was movement in her home ...
MTR-1 Corner Mount STL by user CrookedToe
https://www.printables.com/model/941493-mtr-1-inside-corner-mount
Additional Info
mmWave Presence Sensor Comparison
Please refer to the mmWave guide from the MSR-2: https://wiki.apolloautomation.com/books/msr-2/pa...
Adding CO2 To MTR-1
1. Unplug your MTR-1 from power and remove the back (board shown is msr-1) 2. Remove the board...
Reducing LD2450 Log Entries In Home Assistant
Open your Home Assistant config.yaml Add in this code but use your MTR-1's name logbook: ...
Troubleshooting
Manually Uploading Code Through ESPHome
If your device becomes unresponsive and you've exhausted the other troubleshooting methods you ca...
Putting The MTR-1 In Boot Mode
This will cover how to put the MTR-1 into boot mode. This is sometimes needed for uploading new f...
Teardown and Reassembly of the MTR-1
This will cover how to take apart and reassemble the MTR-1 device. This is useful if you are repl...