Advanced Search
Search Results
11 total results found
Wi-Fi Disconnecting
Try a couple of different power cord and power brick combinations - this matters a lot more than you'd think! Check to see if the sensor's hotspot is showing up. (this means it is not connected to a network) Check the router's connected devices - the devic...
Teardown and Reassembly of the MTR-1
This will cover how to take apart and reassemble the MTR-1 device. This is useful if you are replacing components or to inspect if the mmwave sensor (LD2450) is seated properly. Sometimes during shipping, this can become loose and cause issues with the accurac...
Firstof9's AIR-1 Apex Charts Dashboard
Firstof9 has created this beautiful responsive dashboard with Apexcharts-card custom card from HACS! The colors will change as severity levels change for each of the sensors below. This guide assumes you already have HACS installed. If you do not, please f...
MTR-1 Corner Mount STL by user CrookedToe
https://www.printables.com/model/941493-mtr-1-inside-corner-mount
CO2 Calibration - The Quick method - Desktop Only not mobile
This article will guide you through a simple calibration of your CO2 sensor for any Apollo Automation device! Go to your home assistant dashboard and hit the letter "e" - It will pop up with an entity filter and here we will type in "Calibrate CO2" and sele...
MTR-1 Temperature & Humidity Offsets
Simple Offsets for Temperature and Humidity: Please add these to the bottom of your esphome yaml for your device then click save and install. Once you are finished, you will have two new boxes inside the home assistant esphome integration device page for your...
Teardown and Reassembly of the MSR-2
This will cover how to take apart and reassemble the MSR-2 device. This is useful if you are replacing components or to inspect if the mmwave sensor (LD2410B) is seated properly. Sometimes during shipping, this can become loose and cause issues with the accura...
F.A.Q. ~ Frequenty Asked Questions
This is where our most frequently asked questions will be for now! Question: How much power do your sensors use? Answer: All apollo sensors use 1amp or less, some of them 350-500mA. Question: What all can the MSR-2 LD2410B mmWave sensor go through? ...
How to edit your Sensor's LUX update interval
This guide will show you how to edit the lux updates down to 3-5 seconds. Your sensor is defaulting to 60 seconds for updates to the state of the lux sensor. This is the default for all esphome devices using lux because it uses less Wi-Fi airtime fairness whi...
MostlyChris MSR-2 Review
Even SMALLER Presence Sensor for Home Assistant!
Home Tech Innovations MTR-1 Review
Setup MTR-1 in 3 EASY Steps!