Teardown and Reassembly of the MTR-1

This will cover how to puttake apart and reassemble the MTR-1 into boot mode.device. This is sometimesuseful neededif foryou uploadingare newreplacing firmwarecomponents or to inspect if the devicemmwave sensor (LD2450) is struggling.

Bootseated Buttonproperly. Only

Sometimes

during
1. Unplugshipping, this can become loose and cause issues with the device
2. See the photo below to help access the boot button through the topaccuracy of the case
3. Use a pin to press and hold the boot button, while holding the boot button plug it back into your computer/power and then release the boot button
   

sensor

    4. Continue with uploading the firmware document

Boot and Reset Buttons

1. Unplug the device
2. Slide the back of the case off
3. Remove the device from the case
4. Plug it back into your computer
5. Press and hold the boot button, while holding it press and release the reset button, then release the boot button

https://www.youtube.com/watch?v=r2YhuNolZw4

6. Continue with uploading the firmware document