Skip to main content

Manually Uploading Code Through ESPHome

If your device becomes unresponsive and you've exhausted the other troubleshooting methods you can upload a fresh set of firmware by following the below guide. The utility does need to be run from Chrome or Edge.

  1. Plug your MSR-1 into your computer with a quality USBC cable that supports data transfer

  2. Click

    Navigate to our installer page and click connect belowhttps://apolloautomation.github.io/MSR-1/

    1. Select your Apollo device, it will show with a similar name to the one below and click connect. If you aren't sure which device it is, you can unplug the MSR-1 and see which disappears.

    ComSelection.png

    If no device shows, click cancel and then install the recommended driver that shows on the popup. If you have installed the driver, tried different cables, and it still won't work refer here for putting the MSR-1 in bootloader mode. **NEEDED

    1. Choose to install new firmware Pic needed

    1. Wait for the installer to finish

    Need to put in boot mode with below

    • Back to top