Skip to main content

Adding CO2 To AIR-1

How to add a CO2 module to an existing AIR-1

1. Unplug your AIR-1 from power and remove the back

IMG_3790.jpeg

2. At the bottom center there is a black connector. There is aan x in the lower right corner of the connector


3. Orientate the CO2 module so the white x on the module is also in the lower right and the gold dot is in the upper left as seen below

4. Align the connector on the back of the CO2 module with the connector on the AIR-1. Once aligned, push down so the CO2 module fully seats itself

IMG_3791.jpeg

5. Put your AIR-1 cover on. Please refer to our CO2 calibration guide to calibrate the CO2 module.

Back to top