Advanced Search
Search Results
182 total results found
Our Team
Our Team Page
Simon Says Home Assistant AIR-1 Review
Apollo Air Quality Sensor runs on ESP Home.
Simon Says Home Assistant MSR-1 Review
Check out the Apollo Multisensor MSR-1
BeardedTinker AIR-1 Review
Air-1 - most feature packed Air Sensor I've seen
MSR-1 + Alarmo Home Security Install
My grandmother wanted a security system that would alert her when there was movement in her home after she had gone to bed. So, I set up three of our Apollo Automation mmWave sensors. These devices, plus the Alarmo add-on, quickly and easily allowed me to inst...
MostlyChris MSR-1 Review
The little sensor that does it all! ESPHome and Home Assistant Ready!
Getting Started
Please refer to the general getting started article
Sensor Definitions
Component The ld2450 component enables the use of the HLK-LD2450 human presence and motion detection radar module with ESPHome. HLK-LD2450 Official Datasheet and user manuals Motion target tracking involves real-time tracking of the position of a mo...
Bluetooth Tracking with MTR-1
Please refer to the general Bluetooth tracking article
General Tips
MTR-1 PCB with Sensors Light Sensor (LTR-390UV) When mounting the MTR-1 be sure to position the device so that the large hole at the top is not covered. This allows more light to enter and will ensure better accuracy The onboard RGB LED will trigger...
How To Change The Update Frequency Of Sensors/Force Update
How To Change The Update Frequency Of Sensors/Force Update
Updating MTR-1 Firmware
Please refer to the general firmware update article
CO2 Calibration For MTR-1
Please refer to the General CO2 Calibration article
MTR-1 Home Assistant Dashboard Examples
Radar Scatter Plot With Apex Charts type: custom:apexcharts-card header: show: true title: MTR-1 Radar Distance show_states: true colorize_states: true apex_config: legend: position: top horizontalAlign: center offsetX: -80 ...
Using MTR-1 Buzzer
This guide will walk you through using the buzzer on your MTR-1. You can also use the "action" in an automation in Home Assistant. Open Home Assistant and navigate to developer tools in the bottom left 2. Click on services 3. Choose your MTR-1's...
MTR-1 + Alarmo Home Security Install
My grandmother wanted a security system that would alert her when there was movement in her home after she had gone to bed. So, I set up three of our Apollo Automation mmWave sensors. These devices, plus the Alarmo add-on, quickly and easily allowed me to inst...
mmWave Presence Sensor Comparison
Please refer to the mmWave guide from the MSR-2: https://wiki.apolloautomation.com/books/msr-2/page/mmwave-presence-sensor-comparison
Adding CO2 To MTR-1
1. Unplug your MTR-1 from power and remove the back (board shown is msr-1) 2. Remove the board from the case and orient it like the image below. You will see a black connector on the bottom right, with an 'X' at its lower right corner. 3. Orient the CO2 ...
Reducing LD2450 Log Entries In Home Assistant
Open your Home Assistant config.yaml Add in this code but use your MTR-1's name logbook: exclude: entities: - binary_sensor.hallway_motion_home_security_motion_detection
Manually Uploading Code Through ESPHome
If your device becomes unresponsive and you've exhausted the other troubleshooting methods you can upload a fresh set of firmware by following the below guide. The utility does need to be run from Chrome or Edge. If your device has already been connected to H...